Rockwell Automation FD86N Drive Systems Enclosure Hardware - Manual (Page 24)

2-10 Installing the FD86N Enclosure
Publication S-3062 – November 1997
Installing an Equipment
Enclosure to the
FD86N Enclosure Hardware needed:
•
Eight M6 or ¼-20 thread-forming screws.
To install an equipment enclosure to the FD86N enclosure:
1. Remove the split or top access cover from the equipment enclosure.
Refer to Figure 2.8.
2. Place the equipment enclosure on the FD86N enclosure over the
appropriate cutout.
3. Align the mounting holes. Refer to Figure 2.8.
4. Fasten the equipment enclosure to the FD86N enclosure using the M6
or ¼-20 thread-forming screws.
5. Reinstall the access covers.
Figure 2.8
Installing an Equipment Enclosure to the FD86N Enclosure
Split Access Cover
Top Access Cover
FD86N Enclosure Hood
Typical 27
″
High
Equipment Enclosure
Typical 9
″
HIgh
Equipment Enclosure
Typical 18
″
High
Equipment Enclosure
Cutout
Typical Equipment
Enclosure (Access Covers
Removed)
Split Access Cover