Rockwell Automation FD86N Drive Systems Enclosure Hardware - Manual (Page 33)

Joining Bus Bar Assemblies 3-7
Publication S-3062 – November 1997
Joining Bus Bar Enclosures Hardware needed: M6 or ¼-20 thread-forming screws.
To join bus bar enclosures from an FD86N enclosure to FD86N enclosure,
see Figure 3.8.
To join bus bar enclosures from an FD86N enclosure to an SA3000 or
SB3000, see Figure 3.9.
Figure 3.8
Installing a Sheet Metal Joiner for Bus Bar Enclosures (FD86N to FD86N)
Figure 3.9
Installing a Sheet Metal Joiner on an Overhead Cable Routing Box
(FD86N to SA3000 or SB3000)
Bus Bar Enclosure
Sheet Metal Joiner
Bus Bar Enclosure
M6 or ¼-20
Thread-Forming Screw
FD86N Overhead Cable
Routing Box
Sheet Metal Joiner
SA3000 or SB3000
Bus Bar Enclosure
M6 or ¼-20
Thread-Forming Screw