Rockwell Automation 1734-AENTR EtherNet/IP Network Configuration User Manual - Manual (Page 148)

148 Rockwell Automation Publication ENET-UM001L-EN-P - March 2014
Index
M
map tags 84
messaging
configuring 79 , 82
connections 74
guidelines 73
logic 75
data transfer
logic
78
mapping tags 84
overview 61 , 86
to PLC-5 or SLCcontroller 83
MSG instruction
configuring 79 , 82
connections 74
guidelines 73
logic 75 , 78
mapping tags 84
sending email 94
sending via an email 89 - 95
to PLC-5 or SLC controllers 83
N
network address
DNS addressing 31 - 32
set IP network address 18
network overview
modules in an EtherNet/IP control system 11
network parameters
DNS addressing 18
domain name 18
gateway 17
host name 18
IP addresses 17
subnet mask 17
O
ownership 56
listen-only connection 56
owner controller 56
P
PanelView terminals
adding in Studio 5000 environment 101 - 104
communicating with Logix5000 controller
over an EtherNet/IP network 99 -
106
determining connections 100
organizing controller data 105
set up hardware 99
personal computers
placing on network 13 - 15
PLC-5 controller 83
produce tags 64 , 66 , 67
produced and consumed tags
connections 64
consume tags 68 , 72
organize tags 63
overview 61 , 86
produce tags 66 , 67
set up hardware 62
terminology 64
R
rack-optimized connection 52
remote adapter 57
requested packet interval 58 , 59
ring supervisor
configure with Studio 5000 environment 37
enable in Studio 5000 environment 40
RPI 58
RSLinx software
communication driver 14 - 15
configuring network parameters 25 - 27
setting IP network address 18
S
select a remote adapter 57
set IP network address 18
BOOTP/DHCP server 21 - 23
RSLinx software or RSLogix 5000 software 18
thumbwheel switch 18
set the requested packet interval
with Studio 5000 environment 58 , 59
set up hardware
data transfer 62
I/O modules over EtherNet/IP 47
interlocking 62
messaging 62
PanelView terminals and Logix5000
controllers 99
produced and consumed tags 62
set up I/O
controlling I/O 47
SLC controller 83
status codes
email 96
string tags 89
Studio 5000 environment
adding a PanelView terminal 101 - 104
adding distributed I/O modules 48 , 60
configure a ring supervisor 37
consume a tag 68 , 72
enable ring supervisor 40
produce a tag 66 , 67
set the requested packet interval 58 , 59
setting IP network address 18
software
adding distributed I/O modules 51
verify supervisor configuration 46