Rockwell Automation 1734-AENTR EtherNet/IP Network Configuration User Manual - Manual (Page 46)

46 Rockwell Automation Publication ENET-UM001L-EN-P - March 2014
Chapter 4 Configure a Supervisor on a Device-level Ring Network
Verify Supervisor
Configuration You may want to verify that your supervisor configuration has taken place and
that the ring network is functioning properly. You can verify that configuration
and a normally functioning network in either the Studio 5000 environment or
RSLinx Classic software.
1. Access the module properties as described previously.
2. Click the Network tab.
3. Verify the Network Topology and Network Status fields.
They should display Ring and Normal respectively, as shown below.
You can also verify the supervisor configuration through the module’s diagnostic
web pages. For more information on monitoring diagnostics via an EtherNet/IP
communication module’s web pages, see
Diagnostic Web Pages on page 107 .
Verify these fields.