Rockwell Automation 1734-AENTR EtherNet/IP Network Configuration User Manual - Manual (Page 50)

50 Rockwell Automation Publication ENET-UM001L-EN-P - March 2014
Chapter 5 Control I/O
Add an I/O Module
To add a module to the I/O Configuration folder, follow these steps.
1. In the Controller Organizer, right-click the remote communication
module and choose New Module.
The Select Module dialog box appears.
2. Choose the module you wish to add and click OK.
Depending on the I/O module, the Select Major Revision dialog box
may appear. If the dialog box appears, choose the module’s major revision
and click OK.