Rockwell Automation HPK-Series Asynchronous Servo Motor - Manual (Page 33)

HPK-Series Asynchronous Servo Motors 33
Publication HPK-IN001C-EN-P - June 2010
6. Verify the motor shaft, faceplate, bearing bore, wear sleeve, and keyway are free of nicks,
burrs, grooves, or spiral machine marks.
Motor Cables and Accessory Kits
Accessories available from the factory include motor feedback cables.
Motor Cables
Factory-manufactured feedback cables are available in standard cable lengths. They provide the
sealing necessary to achieve environmental ratings and the required shield termination. For a
complete listing of available cables, contact your nearest Rockwell Automation sales office or
refer to the Kinetix Motion Control Selection Guide.
Specifications
Always store a motor in a clean and dry location within these environmental conditions.
Appropriate mounting, cabling, and a shaft seal may be required to attain a specific IP rating.
IMPORTANT Check the motor shaft and surrounding surfaces. Remove any nicks, burrs, or
surface damage.
Attribute Value
Temperature, Operating 0…40 ° C (32…104 ° F)
Temperature, Storage (1)
(1) Always store a motor in a clean and dry location within these environmental conditions.
-30…70 ° C (-22…158 ° F)
Relative Humidity 5…60% noncondensing (4)
(4) Drain plugs, T-drains, and breathers must be removed or opened to permit breathing. Motors located in a moist environment
must have space heaters to protect against condensation when motor is not operating.
Atmosphere noncorrosive
Shock 10 g peak, 6 ms duration
Vibration 2.5 g, 30...2000 Hz
Ingress Protection Code
(2)
= IP54
(3)
(2) Ingress Protection (IP) ratings are determined by using Rockwell Automation cables to connect to the motor.
(3) Environmentally-sealed connectors and cables are required to achieve an International Protection (IP) rating of IP54 for the
motor.
Dust protected, splashing water
Shaft Material 1040/1045 steel
Encoder Up to 2 million counts per revolution