Rockwell Automation FactoryTalk Transaction Manager User Guide - Manual (Page 32)

●
●
●
●
●
FactoryTalk Transaction Manager User Guide
32
To activate your software using FactoryTalk Activation, first determine
your activation server/client configuration:
 One or more activation servers, one or more clients. You will need
to run the FactoryTalk Activation Server software on the network
computer(s) that will act as the activation server(s). You will need to
run the FactoryTalk Activation Client software on each of the client
computers. Then you will direct the client computers to the activation
server computer.
 Activation server/client on each computer. You will need to run the
FactoryTalk Activation Server software on this computer. This
computer will then act as both the activation server and client.
For more information, see the FactoryTalk Activation online help.
A
CTIVATE
U
SING
E
V
RSI A
CTIVATION
EvRSI activation relied on a physical master disk that used to be supplied
with the FactoryTalk Transaction Manager product. If you are a current user
upgrading to the latest release, your activation is already installed and will
be used automatically.
For more information about EvRSI activation, refer to the Activation Help
(COPYPROT.HLP) by selecting Help > Copy Protection or by clicking
Help on any of the EvMove or Reset dialog boxes.
G
RACE
P
ERIOD
In FactoryTalk Transaction Manager v10.10, the software supports a seven
day activation grace period when a valid activation is not found. During
grace period:
 When a configuration is started following an operating system reboot, a
message is logged to the FactoryTalk Diagnostic log every four hours
until a valid activation is found.
 When a configuration is started from the software itself, you are
prompted to confirm entry into grace period mode. Upon confirmation,
a message is logged to the FactoryTalk Diagnostic log every four hours