Baumfolder Older Folder - Manual (Page 10)

Baumfolder Corporation
Procedure for Setting up a Mechanical Pile Feeder
(Continued)
18. Turn on the pump control and move the lever on the
blow bar so that the top 5 to 8 or 9 sheets of the
stock are separating. Open the butterfly valve that
controls the blow from the pump and then slowly
begin closing it until sufficient amount separate the
sheets about ¾ of the length of the sheet.
19. If the job is set up on the folder, open the butterfly that
controls the vacuum all the way and slowly close it
until the sheets feed at a regular and steady rate.
20. When loading the feeder, use wedges to cause the top sheets to be level if necessary.
** End of Topic - Procedure for setting up a Mechanical Pile Feeder **
Baumfolder Corporation 1660 Campbell Rd. Sidney, OH 45365 Copyright © 2002
Ph: 1-800-543-6107 Fax: 937-492-7280 email: [email protected]
10