Baumfolder corporation, Appendix a - to calibrate caliper – Baumfolder Older Folder User Manual
Page 30
Baumfolder Corporation
Appendix A - To Calibrate Caliper
Turn Caliper Adj. knob counter clockwise and push down until Throw off wheel
contact the Feed Roll. Loosen set screw ( A ) – insert a Dime (10¢ piece) between
Caliper squaring block and Throw off wheel setting lever. Make sure Draw roll
latch is latched on to caliper reset pin. Apply light pressure down on Caliper adj.
knob and tighten set screw ( A ). Remove dime and adjust caliper by turning Caliper
adjust knob clockwise until one (1) sheet of material you are running moves free
between Throw off wheel and the feed roll but not two (2) sheets.
The set screw with the ½” nut on the left side of the Caliper squaring block should be
set so the block slides up and down free but doesn’t rock back and forth.
** End of Appendix A – Calibrating Caliper **
Baumfolder Corporation
1660 Campbell Rd. Sidney, OH 45365 Copyright © 2002
Ph: 1-800-543-6107 Fax: 937-492-7280 email: [email protected]
30