Baumfolder Older Folder - Manual (Page 7)

Baumfolder Corporation
Procedure for Setting up a Mechanical Pile Feeder
(Continued)
6. Loosen the thumbscrew on the air bracket
and blow bar; raise the blow bar as high as
possible. Tighten the thumbscrew.
7. Loosen the two bolts on the air bracket and
move it toward the register table as close as
possible without the blow bar rubbing the pull
out roll. Tighten the two bolts.
8. Adjust the lever
on the blow tube
to a straight up
position so it can
be moved
forward or
backward in the
future. Now
adjust the
circular clips at a
45-degree angle
toward the
feeder. Adjust
the circular clips
on the right and
left front edge of the sheet of paper to be at 90-degree angle.
(continued on next page)
Baumfolder Corporation 1660 Campbell Rd. Sidney, OH 45365 Copyright © 2002
Ph: 1-800-543-6107 Fax: 937-492-7280 email: [email protected]
7