Baumfolder Older Folder - Manual (Page 22)

Baumfolder Corporation
Center Trim Out
(Continued)
When mounting the blade to the blade holder, leave the screws loose, then slide the blade
holder and the blade on the slitter shaft before you tighten the screws. This aligns the blade
and the blade holder so they slide onto the slitter shaft. The parts and the part numbers are
listed below.
For 7/8 slitter shafts
Blade Holder 06411or 06413
Slitter blades (Counter sink beveled side) 06378
Slitter blades (Counter sink flat side) 06804
Screw slitter blade (two per blade) 07728
Center stripper (picture one) 1/8 wide 15701
Center stripper (for wider trim out) ¼ wide 15700
Wire stripper-center brass (picture 2) 1/8 263-781-BG-01
Wire stripper-center brass (wider trim outs) 263-780-BG-01
For 1 1/8 slitter shafts
Blade holder assembly S52083
Slitter blade 93209
Screw slitter blades (three per blade) 07728
Wire stripper brass (all 1 1/8 shafts) 1/8” 267-662-BG-01
Wire stripper brass (all 1 1/8 shafts) ¼” 267-663-BG-01
** End of Topic – Center Trim Out **
Baumfolder Corporation 1660 Campbell Rd. Sidney, OH 45365 Copyright © 2002
Ph: 1-800-543-6107 Fax: 937-492-7280 email: [email protected]
22