Baumfolder Older Folder - Manual (Page 32)

Baumfolder Corporation
Appendix B - Calibrate Pile High Control
(Continued)
To time the feeder for a 3/32” pile rise, rotate the crank great 180 degrees from what is
shown in the picture on the previous page. This will reverse the positions of holes A and B.
Install the lift operating arm in hole B and adjust the latch pin the same as described for the
1/32 - 1/16 rise adjustment.
If heavy stock such as cover stock is being run and the pile doesn’t seem to come up fast
enough, set the feeder to rise 3/32” per ratchet engagement (three ratchet teeth). When
running very light paper, possibly 1/32” (one tooth) will be sufficient. For the usual run of
paper, having the pile rise frequently in shorter strokes attains more uniform separation. By
watching the operation, one can tell what amount of rise to use.
When the correct pile height as been sensed, the latch
pin should engage the pawl lever latch by
approximately 1/32” on contact. (See figure at right)
This is set by adjusting the engagement adjusting
screw under the latch pin.
** End of Appendix B – Calibrating Pile High Control **
** End of Document **
Baumfolder Corporation 1660 Campbell Rd. Sidney, OH 45365 Copyright © 2002
Ph: 1-800-543-6107 Fax: 937-492-7280 email: [email protected]
32