Baumfolder Older Folder - Manual (Page 16)

Baumfolder Corporation
( step 4 continued )
counterclockwise, rocking back and forth to be sure the rollers are seated.
(Note: When setting the #3 and #5 Baumsets, it will be necessary to turn the
handwheel clockwise to roll the strip in place.)
5. Adjust the micro adjustment knob until you can pull the strip of paper out from
between the #1 and stationary roll using a steady, light pull. You should feel an even
drag of the sheet.
6. Tighten the Baumset lock knob. Remove the pull strips.
7. Repeat the procedure outlined in steps #2 through #6 for the #1 RH Baumset.
8. Check the adjustment on both the LH and RH sides of the fold rolls to ensure an even
pull on each side.
9. Repeat the process outlined in steps #2 through #8 for the #2, #3, #4 and #5
Baumsets. Be sure to use the same thickness of paper throughout the calibration.
To set the Zero Baumset dial, remove all the strips of paper from the Baumset adjustment
gap and:
Locate the micro adjustment knob so that the top is level with the top of the lever. The
Zero Baumset dial should be seated on the stem lock nut. It will be necessary to
loosen the stem lock nut and screw the micro adjustment knob up or down if it is not
level with the top of the dial.
At this time, align the triangle on the lever and the triangle on the Zero Baumset dial.
(See triangle alignment illustration on the previous page) Make certain the Baumset
lock knob is tight so the tension screw doesn’t turn while the micro adjustment knob is
adjusted up or down. Recheck the calibration to be sure the tension screw did not turn.
Retighten the stem lock nut.
NOTE: The micro adjustment knob must be level with the lever to ensure a proper
reference point for the triangle alignment in case the micro adjustment knob is turned
360 degrees up or down. If it is not level indicates that the micro adjustment knob
should be readjusted.
Now the Zero Baumset is calibrated. To set up a job, refer to the operation of the Baumset .
(continued on next page)
Baumfolder Corporation 1660 Campbell Rd. Sidney, OH 45365 Copyright © 2002
Ph: 1-800-543-6107 Fax: 937-492-7280 email: [email protected]
16