Baumfolder Older Folder - Manual (Page 18)

Baumfolder Corporation
Setting up a Job – Stacker and Stacker Pan
(Continued)
( step 2 continued )
trailing edge of the sheet/signature down so as the next sheet/signature comes out, it
does not strike the previous sheet/signature. The Stacker Springs can be bent so they
apply enough pressure to hold the sheet/signature in place until the next sheet/signature
comes out. This is used when you don’t want to use the Stacker Wheels. A map fold is an
example of when you would not use the stacker wheels. The bulk of the folds cause the
maps to jam up at the stacker wheels.
3. There are adjustment screws at the rear of the stacker frame to tighten or loosen the
Stacker Belt, to allow it to track straight. If the stacker belt is moving to the left of the
stacker, tighten the left adjustment. Allow several minutes to allow the belt to respond
before you make another adjustment.
4. Install the STACKER PAN. Now you are ready to run.
FIRST RIGHT ANGLE/ EIGHT-PAGE SECTION
( This instruction can be used for any other rollaway units.)
1. Height adjustment may vary depending on the job you run. For an example, if you want
the sheet/signature to overlap (a sheet leaving the parallel at the same time the previous
sheet/signature is in the cross carrier guide moving toward the fold rollers), you would
have the height of the unit lower. Normal height would be that the top of the cross carrier
would be at the bottom of the lower slitter shaft.
2. The purpose of the cross carrier is to accept the sheet/signature out of the previous unit
and instead of stacking, direct the sheet/signature into the next set of rollers. This can be
in tandem (Straight in line with the previous unit) or at a right angle with the previous unit.
3. Lay the sheet/signature as it leaves the
previous unit on the cross carrier with the
trailing edge at the edge of the left side
of the cross carrier rolls. Hold the
sheet/signature so it doesn’t move and
bring the cross carrier guide so it is
against the sheet/signature. Turn the
hand wheel until the sheet enters the
number one fold plate. If the
sheet/signature jams, move the guide
back toward the right side. If this change
has to be made, you have one of the
earlier models Baumfolders.
(continued on next page)
Baumfolder Corporation 1660 Campbell Rd. Sidney, OH 45365 Copyright © 2002
Ph: 1-800-543-6107 Fax: 937-492-7280 email: [email protected]
18