Baumfolder Older Folder - Manual (Page 19)

Baumfolder Corporation
Setting up a Job – First Right Angle
(Continued)
4. Square the guide the same way you squared the register side guide. On older
Baumfolders, there are two bolts on each side of the thumbscrew. Loosen the bolts to
move the guide. On the newer Baumfolder, they have micro adjustments. Once the guide
is squared (90 degrees) with the fold rollers, tighten the bolts.
5. Put two steel marbles in the MARBLE HOLDER in the center where the sheet/signature
enters the Marble Guide and one or two steel marbles in the end of the
MARBLE GUIDE just before the sheet/signature enters the fold rolls. Put glass marbles in
the rest of the Marble Holder. Replace the MARBLE HOLD DOWN. Once you are
running, you may have to change some of the marbles to keep the sheets/signatures
against the guide. This depends on the material you are running. The suggestion given
about the marbles is a starting point.
6. The fold rollers and the fold plates are adjusted the same as the first unit. Refer to the
FOLDER instructions. The STACKER instruction is the same.
7. Always score or perforate in the parallel section before going into the eight page section
(first right angle unit). Scoring is not as important when folding the sixteen-page unit
(second right angle unit). You perforate to allow the air to escape. It might be a good
habit to always score or perforate if you are folding even in the sixteen or thirty-two page
unit.
** End of Topic – Setting up a Job **
Baumfolder Corporation 1660 Campbell Rd. Sidney, OH 45365 Copyright © 2002
Ph: 1-800-543-6107 Fax: 937-492-7280 email: [email protected]
19