Bowers Group Sylvac D100S Readouts - Manual (Page 13)

12
1.6.2 ENTER KEY
- Operating in normal measuring mode: moves directly to preceding channel, adjust contrast or controls descent of probe
with D110 or D110V.
Choose between following three functions:
1/ Press . key 2/ Then press or key
The following menu will appear:
Choice 1 allows you to move directly to the preceding channel by pressing the Enter key, or to the following channel by
pressing the Clear key. Constant pressing is possible.
Choise 2 allocates the Enter and Clear keys for contrast to be adjusted by means of the Enter and Clear keys according
to working conditions (temperature, angle of view).
Choice 3 allocates the Enter and Clear keys respectively to lower or lift probes in service by using the D110 pneumatic
command unit or the D110V vacuum unit.
It is also possible to configure the external contact (pedal) to lift/lower the probes (refer to Section 1.6.11).
- Operating in Min/Max mode: changes the displayed value: maximum, then minimum, then max-min, then
mean (max + min)/2, then maximum again...
- Operating in Set Up mode: confirms an input value or cancels a menu without alteration.
- Operating in Scanning mode: when the last measured values are displayed, Scan mode will be cancelled.
Otherwise, the display will move successively forwards until it reaches the last
values.
- Operating in Stat mode: displays next values.
- Operating in Store mode: reactivates the values erased by Clear.
Enter/Clear =
1: Channel
2: Contrast
3: D110