Bowers Group Sylvac D100S Readouts - Manual (Page 72)

5.4 OPERATION OF D111 OR D111V UNIT
1/ Configure the 1st D110/D110V unit as shown in Section 5.3.
2/ Connect the air supply input marked 'In' on the D111 (V) unit to the output marked 'Out' on the D110 (V) unit or the
D111 (V) using the air tube supplied with this unit.
3/ Connect from 1 to 16 lifters to the outputs of the D111 (V) unit. The unused sockets must have the red plastic cap
fitted.
4/ Adjust the speed of descent of the probes by means of the microflow restrictor on the D110 (V) unit.
The D110 (V) and D111 (V) units require no maintenance.
5.5 TECHNICAL SPECIFICATIONS
D110/D111 (V) units:
Terblend plastic housing (= ASA+Polycarbonate: refer to characteristics described in
Section 1.12).
Polyurethane clip-on legs.
Polycarbonate front panel,
varnished aluminum rear panel.
Degree of IP protection: IP 50 (according to IEC 529)
Weight of unit: - D110 0.9 kg (2 lb)
- D110V 0.8 kg (1.8 lb)
- D111 0.7 kg (1.5 lb)
- D111V 0.7 kg (1.5 lb)
Operating temperature: Between + 5° and + 40°C
Storage temperature: Between - 20° and + 60°C
Control: electrically by display unit D100S
Air supply: filtered and dry, pressure 3 to 6 bar.
71