Bowers Group Sylvac D100S Readouts - Manual (Page 33)

32
13/ Enter nominal size and tolerances for all channels to be scanned (refer to Section 1.6.7).
14/ Put a block gauge (master) under the probes and be ready to calibrate the channels.
15/ Enter the preset values according to the master for all required channels. For a new calibration in scanning mode,
just press Preset when the master is in place.
16/ The system is now ready. Position the workpiece to be measured and when the probes are in the measuring posi-
tion, press the key.
According to the particular channel allocation specified in point 10, scanning will stop at channel 4 and the following
will be displayed:
Take a minimum measurement on channel 4 and then press key or
foot pedal.
In the case of a wrong measurement, the key will allow a new mea-
surement to be taken.
17/ When scanning is completed, the following will be displayed (numerical values are given as examples):
Sequential workpieces numbered: from 1 to max 65 000.
General indication for the measured workpiece from indicator lights. This crite-
ria takes into account the internal or external measurement for each channel
(refer to tolerances in Section 1.6.7).
Display of channel number, measuring mode if channel is in A +/- B mode, and
measured value or, if tolerances are active, of the difference between nominal
size and measured value and graphical display <, = or >.
The following keys are active in Scan mode:
Starts a new scan. Workpiece numbering is done automatically (from 1 to n pieces). For 40 or 80
column printing format, it is also possible to enter an alpha-numerical identification of each scanned
workpiece (refer to Section 1.6.14: Print key).
Displays or removes the tolerance indicators for each channel.
- Tol not activated
: measured value is displayed.
- Tol activated : difference between nominal value and measured value is displayed, follo-
wed by E for an external measurement or I for an internal measurement, and finally by tolerance indi-
cators <, = or >.
The first displayed values show a maximum of 5 channels. Any following channels will be shown by
pressing this key. When the last table is reached (the arrow disappears from the upper-right-hand
side of the display), you can exit scanning mode by pressing this key again.
This key allows display of the preceding table. When the first table is reached (the arrow disappears),
pressing the key again allows you to exit scanning mode.
PIECE 1 :
1 + 5 12.864 E < = >
2 - 6 5.970 E < = >
3 16.004 E < = >
4 18.997 E < = >
5 12.103 E < = >
CHANNEL 4
IN MODE MIN
12.402
follow –> ENTER
or external contact