Metrohm 784 KFP Titrino - Manual (Page 15)

2.4 Configuration, key <CONFIG>
784 KFP Titrino
12
>RS232 settings COM1
baud rate: 9600
data bit: 8
stop bit: 1
parity: none
handshake: HWs
Settings of RS232 interface
see also page 90 Identical for COM2.
Baud rate (300, 600, 1200, 2400, 4800, 9600, 19200,
38400, 57600, 115200)
Data bit (7, 8)
Stop bit (1, 2)
Parity (even, odd, none)
Handshake (HWs, SWline, SWchar, none)
see page 90.
>common variables
C30 0.0
etc.
Values of the common variables
Common variables C30...C39 (0.. ± 999999)
The values of all common variables are displayed. For
creating common variables see page 30.
Settings with key <CONFIG> and power ON
Proceed as follows:
1. Switch the Titrino OFF.
2. Press <CONFIG> and keep it pressed during switching the Titrino ON.
The display shows the following:
lock:
Locking keys <CONFIG>, <PARAM> and <SMPL
DATA>, and the functions "recall method", "store
method" and "delete method" of the internal method
memory in the Titrino.
curve:
Changes the appearance of the curve printout.
>lock
<configuration>: OFF
<parameters>: OFF
<smpl data>: OFF
recall method: OFF
store method: OFF
delete method: OFF
lock
"ON" means that the corresponding function is not
accessible anymore.
The corresponding key is locked.
The corresponding function in the internal method
memory of the Titrino is locked.
Setup
>lock
>curve