4 data card handling (pc cards) – Metrohm 726 Titroprocessor User Manual
Page 24
2.4 Data card handling (PC cards)
726 Titroprocessor, Instructions for use
18
18
2.4 Data card handling (PC cards)
The 726 Titroprocessor can write data onto SRAM storage cards and read
this data in at a later date. The following data cards (memory cards) can be
used as storage cards:
•
6.2245.010 Metrohm Data card (capacity 128 kB)
•
Commercial SRAM cards of any capacity with the hardware format
JEIDA 4.0 (68 pin) as well as PCMCIA cards based on them
Because of different file systems PCMCIA cards cannot be used at
the same time for the 726 Titroprocessor and PCs.
When handling data cards with the 726 Titroprocessor the following points
are important:
Data card preparation
The following preparations are necessary before data cards are used for the
first time:
•
New data cards are supplied with a separately included battery. This
should be inserted in the data card according to the accompanying de-
scription.
•
Data cards can only be inserted in the instrument in the position shown
below. The included label should be attached to the top of the data card.
•
The data card battery has a limited life; this is given in the accompanying
leaflet. In order to avoid accidental loss of data, the date when the bat-
tery is due to be exchanged should be written on the data card label.
•
Before data can be stored on the data card it must be formatted. Pro-
ceed as follows:
•
Insert data card in the 726 Titroprocessor (see above drawing).
•
Select file manager with the softkey [File manager] on the main
page. Change the memory area with the softkey [Change storage],
select 'data card' with the cursor keys and press <ENTER>.
•
If an unformatted card has been inserted a system window appears
on the display. Enter <f> to format the card.
•
A query about the card name is then made. A name with max. 20
characters can be entered; this will now be displayed in the file man-
ager whenever the card is inserted. When the entry has been com-
pleted the data card is formatted with <Enter>.
Label
Notch