Banner LAT-1 Series Laser Alignment Tools - Manual

Visible Laser Device for Aligning Light Screen and Grid Systems
• Self-contained visible-beam laser tool simplifies the alignment of any opposed-
mode sensor pair, especially in applications that include long distances or corner
mirrors
• Reduces the time required to align light screen systems and corner mirrors; elim-
inates much trial-and-error guesswork when working with infrared beams
• Uses one common 9-volt battery (included)
• Built-in circular bubble level
• One 4" x 4" square of high-grade retroreflective target material included for easy
viewing of the laser spot at long distances
• Mounting clip (available separately or as part of a kit; see below) snaps squarely
onto the housings of Banner safety light screen/grid emitters and receivers
Emitter/Receiver Housing LAT-1 with Clip(s) Kit Clip Only
Model Model
MINI-SCREEN® LAT-1-MS MSA-LAT-1
MICRO-SCREEN® LAT-1-US USA-LAT-1
EZ-SCREEN™ LAT-1-SS EZA-LAT-2
EZ-SCREEN™ Type 2 LAT-1-LS LSA-LAT-2
MINI-SCREEN® H.D., EZ-SCREEN™
Grid or Point LAT-1-HD EZA-LAT-1
EZ-SCREEN™ LP LAT-1-LP LPA-LAT-2
All of the Above LAT-1 -
EZ-SCREEN™ Type 2 Heavy Duty LAT-1-LSHD LSHDA-LAT-2
PICO-GUARD™ SFP12 Safety Points LAT-1-SFP12 -
PICO-GUARD™ SFP30 Safety Points LAT-1-SFP30 -
LASER LIGHT
REQUIRES ONE 9V BATTERY
DO NOT STARE INTO BEAM. CLASS 2 LASER PRODUCT.
REMOVE TWO PHILLIPS SCREWS FOR BATTERY ACCESS BELOW
Peak Power:
COMPLIES WITH 21 CFR PART
1040.10 AND EN60825-1; 1994
2.8mW, 640-660nm
33kHz 25% duty cycle
LAT - 1
AVOID EXPOSURE - LASER LIGHT
EMITTED FROM THIS APERTURE
CAUTION: Laser Light Can Damage Your Eyes
• View only the diffuse image of the laser beam where it
strikes the alignment target.
• Always view the laser image from behind the LAT-1.
• Never look directly into the laser lens or into a mirror re-
flection of the laser light beam.
See alignment procedure for more information. Failure to fol-
low these guidelines can result in vision damage.
LAT-1-x Laser Alignment Tool
P/N 054599 Rev. E 9/25/2012
0 054599 0