Banner FI22 Expert Series - Manual

FI22FP Series
Low-Profile, Inline Plastic Fiber Optic Sensor
Printed in USA 01/12 P/N 108899 rev. C
Features
• Low-profile fiber optic sensors are designed for inconspicuous surface mounting
• 8-segment LED light bar indicates relative received signal strength, sensing contrast,
programming status, and diagnostic warnings
• Easy-to-set automatic Expert-style TEACH options including static, dynamic, and
single-point programming plus manual adjustment for fine-tuning
• Smart power-control algorithms to maximize sensing contrast
• Fast 500-microsecond sensing response
• Programmable 30-millisecond pulse stretcher (OFF delay)
• Extreme programming flexibility via two push buttons or a remote input wire
• Output may be programmed for either light or dark operate
• Bipolar discrete outputs: one current sourcing (PNP) and one current sinking (NPN)
• Visible red (660 nm) light source
• Easy-to-read TEACH and signal strength readout, plus indicators for a continuous
readout of operating status
WARNING . . . Not To Be Used for Personnel Protection
Never use this product as a sensing device for personnel protection. Doing so could lead to serious injury or death.
This product does NOT include the self-checking redundant circuitry necessary to allow its use in personnel safety
applications. A sensor failure or malfunction can cause either an energized or de-energized sensor output condition. Consult your
current Banner Safety Products catalog for safety products which meet OSHA, ANSI and IEC standards for personnel protection.
!
Models
* 9 m (30’) cables are available by adding suffix “W/30” to the model number of any cabled sensor
(e.g., FI22FP W/30). A model with a QD connector requires a mating cable (see page 9).
**See page 2 for beam patterns and excess gain curves.
Model Cable*
Supply
Voltage
Output
Type
Maximum Range**
FI22FP
2 m (6.5')
5-wire
integral cable
10V dc to
30V dc
Bipolar
NPN/PNP
Range varies depending on sensing
mode and fiber optic(s) used; see
below and page 2 for typical values.
Opposed Mode
PIT26U Fiber: 60 mm (2.36")
PIT46U Fiber: 260 mm (10.24")
PIT66U Fiber: 540 mm (21.26")
Diffuse Mode
PBT26U Fiber: 15 mm (0.59")
PBT46U Fiber: 65 mm (2.56")
PBT66U Fiber: 115 mm (4.53")
FI22FP Q
Integral 6-pin
Pico-style QD