Banner C-GAGE SLC1 Series Label Sensors - Manual (Page 5)

Dimensions
Remove 4 screws for cleaning.
Use 7/64" hex key
Clearance for
M4 (#8) screws
(2 holes)
10.2 mm
(0.40")
25.4 mm
(1.00")
3.8 mm
(0.15")
32.8 mm
(1.30")
1 mm
(0.04")
8.9 mm
(0.35")
23.1 mm
(0.91")
40.8 mm
(1.61")
88.9 mm
(3.49")
30.5 mm
(1.20")
68.8 mm
(2.71")
SLC1BB6
Label Sensor
SENSING AREA
Green: power on
Green flashing: output overload
Yellow: outputs conducting
bn: +10 to 30 V dc
bu: common
wh: NPN output
bk: PNP output
gy: output invert / reset
Accessories
All measurements are listed in millimeters (inches).
5-Pin Threaded M12/Euro-Style Cordsets (Single Ended)
Model Length Style Dimensions Pinout (Female)
MQDC1-501.5 0.50 m (1.5 ft)
Straight
44 Typ.
ø 14.5
M12 x 1
2
3
4
1
5
1 = Brown
2 = White
3 = Blue
4 = Black
5 = Gray
MQDC1-506 1.83 m (6 ft)
MQDC1-515 4.57 m (15 ft)
MQDC1-530 9.14 m (30 ft)
MQDC1-506RA 1.83 m (6 ft)
Right-Angle
32 Typ.
[1.26"]
30 Typ.
[1.18"]
ø 14.5 [0.57"]
M12 x 1
MQDC1-515RA 4.57 m (15 ft)
MQDC1-530RA 9.14 m (30 ft)
Banner Engineering Corp Limited Warranty
Banner Engineering Corp. warrants its products to be free from defects in material and workmanship for one year following
the date of shipment. Banner Engineering Corp. will repair or replace, free of charge, any product of its manufacture
which, at the time it is returned to the factory, is found to have been defective during the warranty period. This warranty
does not cover damage or liability for misuse, abuse, or the improper application or installation of the Banner product.
C-GAGE SLC1 Series Label Sensor
P/N 59369 Rev. B www.bannerengineering.com - tel: 763-544-3164 5