Q45xdn, Hookup – Banner Q45 Series User Manual

Page 3

Advertising
background image

The Q45X sensor with 45DN expansion card installed requires DeviceNet-compatible
quick-disconnect cable, which is available from various manufacturers, such as
interlinkBT. See table at left.

Q45XDN

P/N 39667 rev. C

3

Banner Engineering Corp.

Minneapolis, MN U.S.A.

www.bannerengineering.com • Tel: 763.544.3164

Q45X Base, Male Connector

Hookup

Figure 3. Q45X Bus Configuration (45DN card installed)

1

5

4

3

2

Shield

Communications -

Communications +

BUS power (-V)

BUS power (-V)

Blue

White

Black

Red

Pin

Function

Wire

Color*

*Wire colors in the table above are for

DeviceNet-compatible cable only.

Specifications – Q45X Series Sensors using 45DN Expansion Cards*

Supply Protection Circuitry

Protected against reverse polarity, transient voltages and loss of ground
(none of these conditions will harm the sensor or interrupt communication on the network)

Response Time

2 milliseconds; total response time will also include the response time of the network

Indicators

On the sensor: Green and Red; visible through the transparent sensor top cover

Green LED lights for dc power “ON”

Red LED(except emitter model Q45X6EQ) is Banner's patented Alignment Indicating Device (AID

,

U.S. patent #4356393) which lights whenever the sensor “sees” a light condition and superimposes a
pulse rate which is proportional to the strength of the received light signal (the stronger the signal, the
faster the pulse rate)

On the 45DN1 and 45DN2 Bus Cards: Green and Red; visible through the transparent sensor top cover

A bi-color LED indicates the status of the network.
Green

Steady

Sensor on line, connected to master

Flashing

Sensor on line - address + baud rate are ok

Red

Steady

Critical network fault or duplicate node address detected; wrong baud rate

Flashing

Minor or connection time-out fault

Operating Conditions

Temperature: -10° to +70°C (-14° to +158°F)
Relative humidity: 95% (non-condensing)

Supply Voltage and Current

11 to 25V dc @ 60 mA (combined current for Q45X sensor and 45DN card)

5

4

1

2

3

* See Q45X datasheet P/N 37735 for further information.

Advertising