Banner M18 Series - Manual (Page 8)

SMB30SK
• Flat-mount swivel bracket with extended range of motion
• Black reinforced thermoplastic polyester and 316 stainless
steel
• Stainless steel swivel locking hardware included
68
57
78
A
B
Hole center spacing: A = 50.8
Hole size: A = ø 7, B = ø 18
Aperture Kits
NOTE: Aperture adds 3/16" to sensor length.
Aperture styles
Round Rectangular
Aperture
(Rectangular type shown)
Lens
Housing
12.7 mm
(0.50")
O-ring (2)
22.4 mm
(0.88")
Outside Diameter
AP18SC
Kit includes round apertures of 0.5 mm (0.02"), 1.0 mm (0.04"), and 2.5 mm (0.10") diame-
ter. Each kit also includes a thread-on aperture housing, a Teflon FEP® lens, and two 0-
rings.
Used with S18, M18.
AP18SR
Kit includes rectangular apertures of 0.5 mm (0.02") wide, 1.0 mm (0.04") wide, and 2.5 mm
(0.10") wide. Each kit also includes a thread-on aperture housing, a Teflon FEP® lens, and
two 0-rings.
Used with S18, M18.
Banner Engineering Corp Limited Warranty
Banner Engineering Corp. warrants its products to be free from defects in material and workmanship for one year following the date of
shipment. Banner Engineering Corp. will repair or replace, free of charge, any product of its manufacture which, at the time it is returned
to the factory, is found to have been defective during the warranty period. This warranty does not cover damage or liability for misuse,
abuse, or the improper application or installation of the Banner product.
THIS LIMITED WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES WHETHER EXPRESS OR IMPLIED (IN-
CLUDING, WITHOUT LIMITATION, ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE), AND
WHETHER ARISING UNDER COURSE OF PERFORMANCE, COURSE OF DEALING OR TRADE USAGE.
This Warranty is exclusive and limited to repair or, at the discretion of Banner Engineering Corp., replacement. IN NO EVENT SHALL
BANNER ENGINEERING CORP. BE LIABLE TO BUYER OR ANY OTHER PERSON OR ENTITY FOR ANY EXTRA COSTS, EXPEN-
SES, LOSSES, LOSS OF PROFITS, OR ANY INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES RESULTING FROM ANY
PRODUCT DEFECT OR FROM THE USE OR INABILITY TO USE THE PRODUCT, WHETHER ARISING IN CONTRACT OR WAR-
RANTY, STATUTE, TORT, STRICT LIABILITY, NEGLIGENCE, OR OTHERWISE.
Banner Engineering Corp. reserves the right to change, modify or improve the design of the product without assuming any obligations or
liabilities relating to any product previously manufactured by Banner Engineering Corp.
EZ-BEAM M18 Series Sensors
www.bannerengineering.com - tel: 763-544-3164