Banner MAXI-AMP Series - Manual (Page 3)

Sensors for use with CR Series Modulated Amplifier Modules
Temperature range for all miniature modulated remote sensors is 0 to 70 degrees C (+32 to 158 degrees F).
Sensors are epoxy-encapsulated and optics are hermetically sealed.
SP100E &
SP100R
Range: 8 inches (20cm)
Beam: infrared, 880nm
Effective beam: .05 inch
(1,3mm diameter)
Cable (all 6-foot lengths):
SP100E: 2-wire ribbon cable
(white, green).
SP100R: 3-wire ribbon cable
(red, black, yellow).
SP100D, DB, C, CCF: 5-wire
ribbon cable (white, green, red,
black, yellow). See hookup
drawing, page 4.
SP100D
Models SP100D and SP100DB are general-purpose miniature diffuse sensors
which detect the reflection of their own light from the surface of an object. The
SP100D is a right-angle design which is generally held in place using a #4 (3mm)
screw. The SP100DB ("B" = Barrel) is an in-line threaded barrel which typically
mounts through a 3/8" (10mm) diameter hole using the lock nuts which are sup-
plied. The optical response of these two sensors is the same.
CONVERGENT Mode Sensors
Models SP100C and CCF are ideally suited to applications where depth of field
is critical. The emitter and receiver are both directed at a point 0.1 inch (2,5mm)
ahead of the front surface. An aperture is included which, when attached, nar-
rows the depth of field (see curves, below). This is particularly useful when it
is necessary to detect an object while ignoring another object or a surface just a
fraction of an inch farther away. The high excess gain at the focus allows detec-
tion of objects of low reflectivity. The SP100C and CCF differ only in housing
style. Model SP100C is for general application. Model SP100CCF is used where
a narrow profile is important for mounting.
Models/Dimensions Excess Gain
SP100E and SP100R miniature opposed sensors have a slim right-angle design
which allows them to be mounted in very tight locations. The thin, flexible rib-
bon cable which exits from one corner may be run in any direction away from
the sensing point. The SP100E and R have a wide beam angle for forgiving
line-of-sight alignment. Alignment is easily made exact (and monitored) using
the AID™ LED on the CR module.
OPPOSED Mode Sensors
DIFFUSE Mode Sensors
SP100DB
SP100C SP100CCF
3
Beam Pattern