Banner MAXI-BEAM Series - Manual (Page 16)

MBCC-412
RF1-2NPS
Cable gland assembly for MAXI-BEAMs. Includes cord
grips for .1 to .4 inch diameter cable. Bracket lockwasher
is also included.
MBC-4 is a 4-pin male industrial-duty connector that
threads into the base of all MAXI-BEAMs. MBCC-412
is a 12-foot long (3,6m) "SJT" type cable. It is inter-
changeable with standard industry types of several
different manufacturers.
Heavy duty 1/4-inch (6mm) zinc plated
steel bracket that allows the MAXI-
BEAM to retrofit to installations of
PHOTOSWITCH series 42RLU and
42RLP sensors. Includes cable gland
and lockwasher.
SMB700P SMB700M
MBC-4
MAXI-BEAM Accessories
Model SMB700 (right) is a general-purpose two-axis mount-
ing bracket that is supplied with a cable gland assembly which
is used to attach the MAXI-BEAM wiring base to the bracket.
The gland assembly is threaded through the bracket and into
the conduit entrance at the base of the scanner block. A large
lockwasher is supplied to hold the scanner block firmly in
place. The bracket is 11-gauge zinc plated steel.
Mounting Brackets
Heavy-duty 1/4-inch (6mm) zinc
plated steel bracket that allows the
MAXI-BEAM to retrofit to installa-
tions of MICRO-SWITCH models
MLS8 or MLS9 sensors. Includes cable
gland and lockwasher.
Model SMB700SS is an 11-gauge stainless steel version of
the SMB700. It is sold alone, without the cable gland assembly
and lockwasher.
Model SMB700F (photo, below) is a flat, single-axis version
of the SMB-700. It is sold without hardware.
Model SMBLS (not shown) is a two-
part bracket assembly which allows ad-
justment in three directions. It consists
of two 11-gauge zinc plated steel right-
angle brackets which fasten together so
that they rotate relative to each other.
The MAXI-BEAM wiring base attaches
to the upper bracket and slots are pro-
vided for vertical adjustment. The bot-
tom bracket is a modified version of the
SMB700. Assembly hardware and a
cable gland are included.
Banner Engineering Corp. 9714 Tenth Ave. No. Minneapolis, MN 55441 Telephone: (612)544-3164 FAX (applications): (612)544-3573
This is a black nylon cable gland assembly for use with
the MAXI-BEAM and other sensors having a 1/2-
NPS conduit entrance. The flexible extension keeps
the sensor cable from bending too sharply, and
mimimizes cable fatigue due to repeated flexing.
The HF1-2NPS includes a neoprene gland that
accommodates cables with diameters from .20 to
.35 inch for a liquid-tight seal.
This flexible gland assembly is resistant to gasoline,
alcohol, oil, grease, solvents, and weak acids. It has
a working temperature range of -30
°
to +100
°
C (-22
to +212
°
F). It is UL recognized and CSA certified.
The HF1-2NPS is sold in packages of 10 pieces.
HF1-2NPS