Banner SL30 Series Slot Sensors - Manual (Page 4)

Banner Engineering Corp. • Minneapolis, MN U.S.A
www.bannerengineering.com • Tel: 763.544.3164 4
P/N 56407E9B
SL Series Slot Sensor
Specifications
Slot Opening 30 mm (1.2”) wide x 45 mm (1.8”) deep overall; beam set in 10 mm (0.4”) from outer edge
Supply Voltage and Current 10 to 30V dc, 30 mA
Supply Protection Circuitry Protected against reverse polarity and transient voltages
Output Configuration Bipolar: NPN (current sinking) and PNP (current sourcing)
Output Rating 150mA, each output
Output Protection Circuitry Protected against false pulse on power-up and short-circuit of outputs
Output Response Time 1 millisecond or 300 microseconds, depending on model
Repeatability 250 microseconds or 75 microseconds, depending on model
Adjustments 4-turn clutched potentiometer sensitivity adjustment
Indicators Green: Power ON/OFF indicator
Yellow: Signal Condition indicator
Construction Housing: ABS/polycarbonate blend
Lenses: Acrylic
Connections IP67, NEMA 6
Environmental Rating 2 m (6.5’) or 9 m (30’) 5-conductor PVC-jacketed attached cable or 5-pin Euro-style quick-disconnect (QD)
connector. QD cables are ordered separately; see page 5.
Operating Conditions Operating Temperature: -40° to +70°C (-40° to +158°F)
Maximum relative humidity: 90% @ 50°C (non-condensing)
Hookups
bn
bu
wh
bk
gy
+
10 - 30V dc
–
Load
Load
(See below*)
Cabled models
bn
bu
wh
bk
gy
+
10 - 30V dc
–
Load
Load
(See below*)
Quick-disconnect models
* For Dark Operate, connect gray wire to + (brown).
For Light Operate, connect gray wire to – (blue).