E-flite BAe Hawk 15 DF ARF - Manual (Page 13)

13 E-flite BAe Hawk ARF Assembly Manual
 10. Slide the wing into position against the
fuselage. Use low-tack tape to keep the wing tight
against the fuselage until the epoxy fully cures.
 11. Repeat Steps 7 through 9 to install the
remaining wing panel to the fuselage.
 12. Before the epoxy cures, use a paper towel
and rubbing alcohol to remove any excess epoxy
that may have oozed out from between the joint
between the wing and fuselage.
Stabilizer Installation
Required Parts
Stabilizer jig center Stabilizer jig side (2)
Right stabilizer
Left stabilizer
Airframe assembly
Required Tools and Adhesives
Medium CA Square
6-minute epoxy Mixing cup
Mixing stick Epoxy brush
Paper towel Rubbing alcohol
Low-tack tape Waxed paper
Ruler Felt-tip pen
Hobby knife w/#11 blade
 1. Use a square and medium CA to glue the
stabilizer jig center to the stabilizer jig side.
The square will keep the center perpendicular
to the side and result in a straight jig. Not doing
so may result in the jig being crooked and could
produce the wrong angle when gluing the
stabilizer halves together.