E-flite BAe Hawk 15 DF ARF - Manual (Page 20)

20 E-flite BAe Hawk ARF Assembly Manual
 5. Slide the pushrod keeper onto the elevator
pushrod wire. Please note that these are the
keepers with the smaller holes in them.
 6. Use needle-nose pliers to bend the pushrod wire
1/4-inch (6mm) from the end of the wire.
 7. Slide the elevator pushrod wire into the elevator
pushrod tube.
 8. Connect the pushrod to the elevator control
horn by sliding the bend from the pushrod
wire into the hole in the elevator control horn.
Use the pushrod keeper to secure the wire to
the elevator control horn.
 9. Repeat Steps 3 through 8 to install the remaining
elevator control horn and pushrod wire.