E-flite BAe Hawk 15 DF ARF - Manual (Page 29)

29 E-flite BAe Hawk ARF Assembly Manual
Motor Battery Installation
Required Parts
Assembled airframe
Hook and loop strap
Motor battery
Required Tools and Adhesives
Scissors
 1. Overlap the hook and loop strap as shown. Use
scissors to cut the strap in half down the middle.
 2. Slide the strap through the slots in the
battery/radio tray as shown.
 3. Position the motor battery in the fuselage
and use the hook and loop strap to secure it
inside the fuselage.
You may have to remove the excess part of
the servo arm on the elevator and the steering
servo for clearance of the main battery.
Accessory Installation
Required Parts
Wing tip plate (2) Air intake scoop (2)
Required Tools and Adhesives
Canopy glue Low-tack tape
 1. The wing tip plates are glued in position using
canopy glue. The longer section of the plate will
be on the top of the wing. Insert the pin in the
plate into the pre-drilled hole in the leading edge
of the wing. Use low-tack tape to hold the plate in
position until the glue has fully cured. Try to keep
the wing fences as parallel to the flight path as
possible while the glue dries.