E-flite BAe Hawk 15 DF ARF - Manual (Page 6)

6 E-flite BAe Hawk ARF Assembly Manual
 12. Use a #1 Phillips screwdriver and four 2mm x
8mm sheet metal screws to secure the fan assembly
inside the fuselage.
Aileron Servo Installation
Required Parts
Left wing panel Right wing panel
2.5 x 10mm sheet metal screw (4)
Aileron servo mount (2)
Servo mounting strap (2)
Required Tools and Adhesives
Servo (2) Medium grit sandpaper
6-minute epoxy Phillips screwdriver: #1
 1. Relocate the string from the aileron opening so it
is near one of the corners. This will give full access
to the opening and prevent accidentally gluing the
string into the wing.
DO NOT remove the string from the wing. The
string will be used to pull the aileron servo
lead through the wing later in this section.
 2. Measure and mark the opening for the aileron
servo 3/4-inch (19mm) from the edge that is
closest to the wing tip as shown. The edge of the
aileron servo mount will align with these marks
when it is installed. Center the mount fore/aft in the
opening for the aileron servo.
 3. Lightly sand the aileron servo mount using
medium grit sandpaper. This will allow the glue to
penetrate into the mount and provide a better bond
between the mount and wing.