E-flite Mini Funtana X ARF User Manual
Page 21
2. Slide three hinges into the slits in the aileron.
Center the slot in the hinge with the hole drilled
in Step 1. Place a T-pin in each hinge to prevent
it from being pushed into the wing when
installing the aileron.
Note:.Do.not.use.CA.accelerator.during.the.
hinging.process..The.CA.must.be.allowed.to.
soak.into.the.hinge.to.provide.the.best.bond..
Using.accelerator.will.not.provide.enough.time.
for.this.process.
3. Slide the aileron into position. Check to
make sure it can move without interference at
the wing root and wing tip. Remove the T-pins
and apply Thin CA to each hinge. Make sure
the hinge is fully saturated with CA. Use a paper
towel to clean up any excess CA from the wing
and aileron. Make sure to apply CA to both sides
of the hinge.
21