E-flite Mini Funtana X ARF - Manual (Page 44)

 1. Turn on the transmitter and receiver of your Mini
FuntanaX. Check the movement of the rudder
using the transmitter. When the stick is moved
right, the rudder should also move right. Reverse
the direction of the servo at the transmitter if
necessary.
 2. Check the movement of the elevator with the radio
system. Moving the elevator stick down will make
the airplane elevator move up.
 3. Use a ruler to adjust the throw of the elevator,
ailerons and rudder. Adjust the position of
the pushrod at the control horn to achieve the
following measurements when moving the sticks to
their endpoints
Low rate (U/D) High Rate (U/D)
Elevator: 3/4" (19mm) 2 5 /
16
" (58mm)
Ailerons: 1" (25mm) 1 7 /
8
" (48mm)
Rudder: 1 3 /
4
" (95mm) 2 3 /
4
" (95mm)
Control Throws
44