GBC EBA 721-05 LT - Manual (Page 10)

- 10 -
EBA 721-05
04-01
88
88
67-03
Multiple cuts function start
- Enter the cut size on the display.
- Press
button
© advances to the
measurement.
- Push the paper to the backgauge.
- Release the cut.
- Press
button
© "A" appears on the middle
display.
- Enter the multiple cut size.
- Press
button
© backgauge will advance by
the multiple cut size.
- After the cut the backgauge advances to the next
multiple cut size.
If, when inserting the multiple cut size, the
M
button
is pressed instead of the button the LED "M"
(12) will light and after every cut the button
must be pressed.
Exiting program-mode
- Press
M
button
© LED "M" (12) is cleared on the
display. The actual size is shown.
3.3 Cutting activation
Danger!
Do not reach into the cutting area when the
blade is in motion.
A cut can only be activated when the specified size
is approached. The LED "S" on the display must be
deleted and the safety area (38) free.
- Press both buttons of the safety two-handed
control system (1) simultaneously and keep them
pressed until the paper is completely cut.
Cutting stop or interruption:
- Release both buttons of the two-hand control (1).