GBC EBA 721-05 LT - Manual (Page 14)

- 14 -
EBA 721-05
88
88
67-06
cm
inch
Working with programs
- Press
P
.
- Enter program number
0 1
...
4 0
.
- Press
© proceeds to position.
- Insert the paper and push it with the paper knock-
up block (6) to the backgauge.
- Release the cut
© after every cut the backgauge
advances to the next position.
The cutting activation is described under
No. "3.3 Cutting activation".
With buttons and you are able to change
between several program steps.
With
the backgauge moves to the indcated
dimension.
With
the backgauge stops.
LED "S" is on
© specified dimension not achieved.
LED "S" is off
© specified dimension achieved.
button is pressed - backgauge stops and the
actual dimension is shown.
Exiting program-mode.
Press
P
3.6 Basic Settings
Display in cm or inch
Press
© display changes between cm and
inch. The corresponding LED light will be on.
Display brightness
Press +
D
display changes between light
and dark.
Cutting counter
Press +
S
number of cuts are shown.
Press
D
twice to delete the counter.
Press to escape the program mode