GBC EBA 721-05 LT - Manual (Page 9)

- 9 -
88
88
67-02
Calculating:
e.g.
2 0 - 2 © Backgauge advances to
the calculated measurement of 18.
Cut according to markings
- Adjust the backgauge (16) to the back.
- Insert paper and move by means of the paper
knock-up block to the backgauge.
- Turn the hand-wheel (17) to the front until the
marking on the paper to be cut is below the
cutting line indicator. The more the hand-wheel is
turned the faster the backgauge will move. For
quick motion use key (18).
- Release the cut.
Optical cutting line indicator
An optical cutting line (45) indicates the exact
position of the cut. The light beam indicates where
the cut will be made.
Mechanical cutting line indicator
The clamp (24) can be used as cutting line
indicator for exact cutting. Pre-clamping can be
performed using the foot pedal (8).
Eject function
If button
E
is pressed, the backgauge will advance
to the preset measurement, ejecting the material to
be cut, then automatically return to the position
shown on the display.