GBC EBA 721-05 LT - Manual (Page 12)

- 12 -
EBA 721-05
88
88
67-04
3.5 Programming
This control system enables you to store 40
programs with 36 programmable steps. One step
represents one measurement or max. 9 multiple
cuts.
P
Program
S
Step
M
Memory (multiple cut)
Memory (multiple cut with automatic control
after the cut)
Program up
Program down
C
Clear
D
Delete
I
Insert
E
Eject
Clear Program
The indicated program step can be overwritten at
any time. These programs remain stored when the
machine is off. Should you change to another
dimension unit all programmed measures are
converted into the new unit (cm and inch).
Entering a program
- Press
P © "PR" appears on the display.
- Enter program number
0 1
...
4 0
.
© The
number will be shown on the display (10). If
measurement is shown on the display (15) the
program is reserved.
- Enter a measurement or advance with the hand-
wheel.
-
=
Store the measurement.
- Enter the next measurement.
-
=
Store the measurement.
-
P
Escape the program mode.
Eject function program
This eject function can be added each time a
measurement is entered and ejects before
advancing to the next measurement.
- Enter the measurement.
- Press
E © LED "E" appears.
- Press
=
Multiple cut program
- Press until the multiple cut size is reached.
Maximum 9 multiple cuts can be entered.
- Enter multiple cut size.
-
=
Store the dimension.