Reloop JOCKEY 3 ME INKL. TRAKTOR LE 2 - Manual (Page 50)

ENGLISH
50
IN1 = Mix
If the Input Routing is switched to MIX, the input signal will be routed directly to the mixer. If the
Deck Select Switch -30- is switched to IN1 both decks A and C in Traktor are mute. Only the analog
signal is audible.
IN1 = Off
IN1 is switched to mute.
4.3 ANALOG MIXING FUNCTION
The Jockey 3 can also be used as 2 channel mixing console without the necessity to involve a computer.
To do so both Deck Select Switches -T30- have to be switched to IN1 and IN2 respectively. Both Rou-
ting Switches -F49- and -F50- have to be switched to MIX.
Depending on which sources are connected to the Jockey 3 -B66-, -B67-, it is possible to switch each
deck to phono (turntables) or line (CD-players) -B65-.
Via the Cue Buttons -T35- it is possible to monitor the signal on each side. Via the Cue Mix Fader
-T40- it is possible to simulate a mix through your headphones.
4.4 OUTPUTS
The jockey 3 disposes of three stereo output channels on the device‘s rear side.
Master 1 -B63- as RCA output as well as Master 2 -B62- as symmetrical 6.3 mm jack output are
adjusted via the Master Volume Encoder -T37-.
The Booth Output -B64- as RCA output is adjusted via the Booth Dial -T38-.
4.5 MASTER THRU AND CUE MASTER THRU
The Master Thru function is especially convenient for setups with 2 DJs. The second DJ‘s output signal
is emitted via the 3.5 mm jack -B61- through the Jockey 3 to master. If you wish to monitor the signal
at the Jockey 3, the monitoring function can be activated with the Cue Master Thru Switch -F53-.
5. DEVICE SETTINGS & TESTS
A few adjustments and tests can be carried out with the Jockey 3 directly, without the need for a
computer. In the following a few items are explained in detail.
5.1 MENU FOR MIDI CHANNEL ASSIGNMENT
AND JOG WHEEL RESOLUTION ADJUSTMENTS
In order to access the setup menu proceed as follows:
1. Make sure that the Jockey 3 is turned off (see position On/Off Button -B56-).
2. Press and hold the Shift Button -T23- and turn on the Jockey 3 via the On/Off Button -B56-.
3. Now release the Shift Button -T23-.
Now you have the possibility to adjust the MIDI channel assignment and the jog wheel resolution.