Reloop JOCKEY 3 ME INKL. TRAKTOR LE 2 - Manual (Page 52)

ENGLISH
52
5.3 AUTO SETUP
Herewith it is possible to carry out an auto setup. The auto setup is used to solve problems and
should be carried out in case the Jockey 3 does not work correctly.
1. Make sure that the Jockey 3 is turned off (see position On/Off Button -B56-).
2. Press and hold the right Play Button -T27- and turn on the Jockey 3 via the On/Off Button -B56-.
3. Now release the Play Button -T27-.
4. The auto setup will now be carried out.
5. In order to complete the auto setup press the right Play Button once again -T27-.
5.4 FIRMWARE VERSION CHECK
In order to verify your current Jockey 3 firmware version proceed as follows:
1. Make sure that the Jockey 3 is turned off (see position On/Off Button -B56-).
2. Press and hold the right Shift Button -T23- and turn on the Jockey 3 via the On/Off Button -B56-.
3. The LEDs of the left FX Parameter 3 Encoder will now be illuminated. The number of illuminated
LEDs corresponds to the currently installed firmware version.
4. In order to stop this display release the Shift Button -T23- and reboot the device.
5.5 JOG DRAG
The Jockey 3 offers the possibility to adjust the jog wheel‘s drag for each jog wheel, according to
one‘s desires. In order to adjust the jog wheel‘s drag turn the respective Jog Drag -S69- to the desi-
red position.
5.6 JOG SENSITIVITY
Via the dial -B58- the jog wheel sensitivity can be adjusted.
5.7 LED DIMMER
Via the dial -B59- the LED background illumination for all LEDs can be adjusted.
6. UPDATES & SUPPORT
6.1 FIRMWARE UPDATE
For the Reloop Jockey 3 it is possible to update its firmware. Consequently it is possible to carry
out adjustments as well as add new features. An instruction regarding this issue can be found online
under the below mentioned address.