Revel F30 - Manual (Page 11)

Figure 6. Installing a
set of spikes on a
REVEL PERFORMA F30
loudspeaker.
INSTALLING SPIKES
After choosing a final placement, add spikes as follows:
1. Remove the spike feet, lock nuts, and wrench from the plastic bag.
2. Lay a REVEL PERFORMA F30 loudspeaker on its side on a
carpeted area or soft towel. Use caution to avoid touching the
tweeter and midrange. Remove the four black screws that serve
as glides and store them for future use. Start a set of spikes, as
shown in Figure 6. Be sure to thread each spike the same
amount to achieve a level placement.
3. Using the supplied wrench, tighten a lock nut onto each spike.
NOTE: If the loudspeaker is to be used on a hardwood or tile floor,
use the round ends with optional supplied covers. Further adjust-
ment of each spike may be necessary due to uneven floors.
4. Stand the REVEL PERFORMA F30 loudspeaker upright in its
final placement position. Again, use caution to avoid touching
the tweeter and midrange.
5. Repeat steps 1 through 4 for the other loudspeaker.
REVEL PERFORMA F30
Owner’s Manual
11
R E V E L
7⁄ 8" max.
Lock Nut
HARD FLOORS
round end
or Dome
Cover Slip
Cover
Foot
Spike
Lock Nut
CARPETED FLOORS
spike end
Foot
1 1⁄ 8" max.
Spike
Carpeted Area or
Soft Towel
REVEL PERFORMA F30
(on its side)