Connections – Revel F30 User Manual
Page 12
Figure 7. Wire gauge versus
maximum wire run (with a
maximum loop resistance of
0.07 ohms) for less than 0.2 dB
response error.
NOTE: “Loop resistance” is the
DC resistance measured at one
end of a loudspeaker cable, with
the other ends shorted together.
CONNECTIONS
REVEL PERFORMA F30 loudspeakers can be connected to
your audio system in three different ways: single-wired, bi-wired, or
bi-amplified. Please read the following three sections before pro-
ceeding with the actual connections. Also, be sure to observe the
following points:
• Use high-quality speaker cable with a maximum total loop resis-
tance (for each wire run) of 0.07 ohms or less. Use the chart in
Figure 7 below to determine the maximum wire gauge.
NOTE: A high loop resistance will result in mis-termination
of the filter networks, and serious degradation of sound
quality. Use high-quality connectors on the speaker cables.
Consult your Revel dealer as to specific recommendations for
your application.
• Turn off all audio system power before making any connections.
• Read the owner’s manuals that were included with your audio
components to confirm their connection procedures.
• Verify correct polarities (i.e.,
+
to
+
and
−
to
−
) when making
connections. Failure to do so will cause poor imaging and
diminished bass response.
• For bi-wired or bi-amplified applications, remove the shorting
straps on the rear of each REVEL PERFORMA F30 loudspeak-
er (refer to Figures 9, 10, and 11 on the next three pages).
REVEL PERFORMA F30
Owner’s Manual
12
W
IRE
G
AUGE
(AWG) L
ENGTH
(
FEET
)
L
ENGTH
(
METERS
)
6
87
27
7
69
21
8
58
18
9
43
13
10
34
10
11
27
8
12
22
7
13
17
5
14
14
4
15
11
3
16
9
3
17
7
2
18
5
2