Revel F30 - Manual (Page 15)

Figure 11. How to connect the
REVEL PERFORMA F30
loudspeaker in a horizontal
bi-amplified system.
HORIZONTAL BI-AMPLIFIED SYSTEM
Using two amplifier channels, remove the shorting straps from
the rear panel; then connect each REVEL PERFORMA F30 loud-
speaker, as shown in Figure 11.
CAUTION: Failure to remove the shorting straps when
bi-amplifying may damage some amplifiers.
NOTE: If the “gain factor” of the two amplifier channels is not identi-
cal, a means of adjusting the input level of at least one of the channels
is required. Consult your Revel dealer for specific recommendations.
REVEL PERFORMA F30
Owner’s Manual
15
Install straps for single-wire operation
Install straps for single-wire operation
Low Frequency Input High Frequency Input
Remove straps
for bi-wire
or bi-amp
+1 -1 0 +.5 -.5
Front Tweeter Level (dB)
Serial Number Revel
Northridge, California
Made in U.S.A.
xxxx
Install straps for
single-wire operation
Low Frequency Input High Frequency Input
Remove straps
for bi-wire
or bi-amp
+1 -1
0 +.5 -.5
Front Tweeter Level (dB)
Serial Number
xxxx
Revel
Northridge, California
Made in U.S.A.
Shorting Straps Removed
INPUT
(one channel shown –
use for low frequencies)
Amplifier
(rear)
INPUT
(one channel shown –
use for high frequencies)
Amplifier
(rear)
red blk
Pre-Amplifier
(rear) OUTPUT OUTPUT
(Optional “Y” Adaptor)
(one channel shown)
REVEL
PERFORMA
F30
Rear
Connector
Panel