Revel F30 - Manual (Page 14)

Figure 10. How to connect the
REVEL PERFORMA F30
loudspeaker in a vertical bi-
amplified system.
CONNECTIONS (CONTINUED)
BI-AMPLIFIED SYSTEM CONNECTIONS
A bi-amplified system may provide increased sonic performance,
with independent amplifier channels separately driving each set of
high- and low-frequency transducers. You can connect REVEL
PERFORMA F30 loudspeakers in a vertical or horizontal bi-
amplified system without requiring an extra electronic crossover.
VERTICAL BI-AMPLIFIED SYSTEM
Using two identical amplifier channels, remove the shorting straps
from the rear panel; then connect the REVEL PERFORMA F30
loudspeakers, as shown in Figure 10.
CAUTION: Failure to remove the shorting straps when
bi-amplifying may damage some amplifiers.
NOTE: When using two dissimilar amplifiers, connect the REVEL
PERFORMA F30 loudspeakers in a horizontal bi-amplified system (see
next section).
REVEL PERFORMA F30
Owner’s Manual
14
Install straps for single-wire operation
Install straps for single-wire operation
Low Frequency Input High Frequency Input
Remove straps
for bi-wire
or bi-amp
+1 -1 0 +.5 -.5
Front Tweeter Level (dB)
Serial Number Revel
Northridge, California
Made in U.S.A.
xxxx
Install straps for
single-wire operation
Low Frequency Input High Frequency Input
Remove straps
for bi-wire
or bi-amp
+1 -1
0 +.5 -.5
Front Tweeter Level (dB)
Serial Number
xxxx
Revel
Northridge, California
Made in U.S.A.
Shorting Straps Removed
Amplifier
(rear)
Ch.1 Ch.2
INPUT INPUT
red blk
Connector
Panel
(Optional “Y” Adaptor)
(one channel shown)
Pre-Amplifier
(rear) OUTPUT OUTPUT
Connector
Panel
(one channel shown)
REVEL
PERFORMA
F30
Rear