Revel F30 - Manual (Page 16)

Figure 12. Location of the
TWEETER LEVEL
CONTROL and its initial setting
for the REVEL PERFORMA
F30 loudspeaker.
SYSTEM OPTIMIZATION
1. After connecting the REVEL PERFORMA F30 loudspeakers,
initially set the TWEETER LEVEL CONTROL on both rear
panels to the “0” position, as shown in Figure 12.
2. Turn on the system power and play a favorite piece of music.
Slowly increase the volume to a comfortable level and listen
from your main listening position. If desired, experiment with
placement (see page 8) to achieve the best overall tonal balance,
image specificity, and spaciousness.
3. You may also wish to further adjust each TWEETER LEVEL
CONTROL. Varying the control will change the high frequency
balance and timbre. Differences in room acoustics often demand
different level control settings.
NOTE: Set the controls the same on both left and right channels.
CABINET CARE
Each cabinet for the REVEL PERFORMA F30 loudspeaker has a
wood veneer finish and does not require any routine maintenance.
Occasionally, use a soft cloth, dampened with household furniture
polish, to remove any fingerprints or dust. Clean the grille by gen-
tle vacuuming.
REVEL PERFORMA F30
Owner’s Manual
16
Install straps for single-wire operation
Install straps for single-wire operation
Low Frequency Input High Frequency Input
Remove straps
for bi-wire
or bi-amp
+1 -1 0 +.5 -.5
Front Tweeter Level (dB)
Serial Number Revel
Northridge, California
Made in U.S.A.
xxxx
Low Frequency Input High Frequency Input
Remove straps
for bi-wire
or bi-amp
+1 -1
0 +.5 -.5
Front Tweeter Level (dB)
Serial Number
xxxx
Revel
Northridge, California
Made in U.S.A.
Connector
Panel
Set Tweeter
Level Control
To “0”
REVEL
PERFORMA
F30
Rear