Revel F30 - Manual (Page 4)

Figure 2. Transducer and con-
nection locations for the REVEL
PERFORMA F30 loudspeaker.
DESCRIPTION
The REVEL PERFORMA F30 loudspeaker features a transducer
complement (see Figure 2) of one 10-inch (250 mm) woofer, a
5.25-inch (133 mm) midrange driver, and a 1-inch (25 mm) tweeter.
Combined with an individually-optimized crossover network, this
transducer arrangement results in a superior off-axis response that
provides a large “listening window” and an uncolored in-room
response, even in the presence of strong wall reflections.
WOOFER
The 10-inch (250 mm) inverted aluminum-dome woofer features:
• True pistonic operation for increased freedom from coloration.
• Optimized and shielded magnetic circuits to minimize harmonic
distortion and prevent interference with video monitors.
• Butyl rubber surround for large, linear excursion capabilities.
• CCA (carbon composite aluminum) flat-wire voice coil on a
2–inch (50 mm) fiberglass bobbin for low mass with high
power handling.
• Vented center-pole piece for better cooling and low compression.
REVEL PERFORMA F30
Owner’s Manual
4
Install straps for single-wire operation
Install straps for single-wire operation
Low Frequency Input High Frequency Input
Remove straps
for bi-wire
or bi-amp
+1 -1 0 +.5 -.5
Front Tweeter Level (dB)
Serial Number
Revel
Northridge, California
Made in U.S.A.
xxxx
REVEL PERFORMA F30 Front
(without grilles)
REVEL PERFORMA F30 Rear
Tweeter
Woofer Port
Tweeter
Level Control
Midrange
Woofer
Connectors (with
shorting straps)