Tweco 400 Ultra-Cut XT Plasma Cutting System - Manual (Page 42)

ULTRA-CUT 100 XT/200 XT/300 XT/400 XT
3-14 INSTALLATION Manual 0-5297
Avoid the following:
1. If you need to pull the cable through a power track do not fold the fiber back on itself making a sharp bend
where it exits the hose.
Art # A-09417
2. Do not hook onto the fiber to pull on the cable.
Art # A-09418
3. Once the fiber cable is installed in the CCM or gas control make sure the strain relief nut is securely tightened
onto the hose so the hose can’t pull out of it like this:
Art # A-09677_AB
Hose not secured in
the Strain Relief