Tweco 400 Ultra-Cut XT Plasma Cutting System - Manual (Page 60)

ULTRA-CUT 100 XT/200 XT/300 XT/400 XT
3-32 INSTALLATION Manual 0-5297
4. Secure the thin nut on the through hole protector so both nut faces are tight against the sheet metal inside
and out.
Art # A-09149_AB
5. Plug the Fiber Optic Cable into the PCB as shown below. Make sure the locking tabs are engaged.
Fiber Optic Cable to/from
CCM plugs in here
Art # A-11999