Introduction fabricator 211i – Tweco 211i Fabricator User Manual

Page 25

Advertising
background image

INTRODUCTION

FABRICATOR 211i

Manual 0-5157

2-1 INTRODUCTION

SECTION 2: INTRODUCTION

2.03 Receipt Of Equipment

When you receive the equipment, check it against the

invoice to make sure it is complete and inspect the equip-

ment for possible damage due to shipping. If there is any

damage, notify the carrier immediately to file a claim.

Furnish complete information concerning damage claims

or shipping errors to the location in your area listed in the

inside back cover of this manual.
Include all equipment identification numbers as described

above along with a full description of the parts in error.

2.04 Description

The Tweco Fabricator 211i is a self contained single

phase multi process welding system that is capable of

performing MIG (GMAW/FCAW), STICK (SMAW) and

LIFT TIG (GTAW) welding processes. The Power Source

is equipped with an integrated wire feed unit, digital volt-

age and amperage meters, and a host of other features

in order to fully satisfy the broad operating needs of the

modern welding professional. The Power Source is also

fully compliant to Standard CSA E60974-1-00 and UL

60974.1.
The Tweco Fabricator 211i provides excellent welding

performance across a broad range of applications when

used with the correct welding consumables and proce-

dures. The following instructions detail how to correctly

and safely set up the machine and give guidelines on

gaining the best efficiency and quality from the Power

Source. Please read these instructions thoroughly before

using the unit.

2.01 How To Use This Manual

To ensure safe operation, read the entire manual, including

the chapter on safety instructions and warnings.
Throughout this manual, the words WARNING,

CAUTION, and NOTE may appear. Pay particular attention

to the information provided under these headings. These

special annotations are easily recognized as follows:

WARNING

Gives information regarding possible electrical

shock injury. Warnings will be enclosed in a

box such as this.

!

WARNING

A WARNING gives information regarding pos-

sible personal injury.

CAUTION

A CAUTION refers to possible equipment

damage.

NOTE

A NOTE offers helpful information concerning

certain operating procedures.

You will also notice icons from the safety section appear-

ing throughout the manual. These are to advise you of

specific types of hazards or cautions related to the por-

tion of information that follows. Some may have multiple

hazards that apply and would look something like this:

2.02 Equipment Identification

The unit’s identification number (specification or part

number), model, and serial number usually appear on a

nameplate attached to the control panel. In some cases,

the nameplate may be attached to the rear panel. Equip-

ment which does not have a control panel such as gun

and cable assemblies is identified only by the specifica-

tion or part number printed on the shipping container.

Record these numbers on the bottom of page i for future

reference.

Advertising
This manual is related to the following products: