Fabricator 211i installation/setup – Tweco 211i Fabricator User Manual

Page 34

Advertising
background image

FABRICATOR 211i

INSTALLATION/SETUP

INSTALLATION/SETUP

3-2

Manual 0-5157

WARNING

The Fabricator 211i must be electrically connected by a qualified electrical trades-person. Damage to the

PCA (Power Control Assembly) could occur if 265 VAC or higher is applied to the Primary Power Cable.

WARNING

ELECTRIC SHOCK can kill; SIGNIFICANT DC VOLTAGE is present after removal of input power. DO NOT

TOUCH live electrical parts.

SHUT DOWN welding power source, disconnect input power employing lockout/tagging procedures. Lock-out/tagging

procedures consist of padlocking line disconnect switch in open position, removing fuses from fuse box, or shutting

OFF and red-tagging circuit breaker or other disconnecting device.
Power Cords Included With Power Supply
Attached to the power supply is an input power cord with a 208/230Volt 50 Amp NEMA 6-50 P for plug. Supplied

adapter allow for connection of the power supply input cable plug to 115 V input power.

Art# A-11275

Figure 3-1: 115 VAC Adapter

Electrical Input Requirements

Operate the welding power source from a single-phase 50/60 Hz, AC power supply. The input voltage must match one

of the electrical input voltages shown on the input data label on the unit nameplate. Contact the local electric utility

for information about the type of electrical service available, how proper connections should be made, and inspection

required. The line disconnect switch provides a safe and convenient means to completely remove all electrical power

from the welding power supply whenever necessary to inspect or service the unit. The Welding Power Source must be:
Do not connect in input (WHITE or BLACK) conductor to the ground terminal.
Do not connect the ground (GREEN) conductor to an input line terminal.
• Correctly installed, if necessary, by a qualified electrician.
• Correctly earthed (electrically) in accordance with local regulations.
• Connected to the correct size power point, fuse and primary supply lead based on Table 3-1.
Refer to Figure 3-1 and Table 3-1.

Advertising
This manual is related to the following products: